







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Bathroom Remodeling: The Garden Grove Owner’s Guide
We install Wellborn bathroom cabinetry and the parts that keep it working, and a full Wellborn bathroom remodel in Garden Grove typically runs $9,000 – $28,000 installed, with single-component replacements priced far below that. Cabinet-specific work, like a vanity swap or a door and hinge correction, usually prices out well under the full range, and we can tell you which side of the line you’re on after a free estimate. We’re an independent service provider, not affiliated with Wellborn.
Owners usually find the problem the same way. A vanity door droops and won’t sit flush. A drawer stops closing all the way unless you push twice. Or the cabinet box around the sink has started to swell at the bottom, which in Garden Grove is almost always moisture wicking up through a failed seal rather than a defect in the cabinet itself. Wellborn builds solid product; what fails is the hardware, the caulk line, and the substrate underneath.
Which Wellborn Models This Applies To

Wellborn makes bathroom cabinetry across several lines, and the part you need depends on which one you have. The cabinet interior usually carries a label with the series and finish, often on the inside of a door or on the back panel of a drawer box. If the label is gone, measure the door overlay and the hinge boring pattern. Wellborn uses a standard 35mm hinge cup on most framed and frameless bathroom lines, but the overlay distance and the mounting plate vary by series, and a replacement hinge with the wrong overlay will leave a visible gap or cause the door to bind against the frame. That is the single most common compatibility mistake we see in Garden Grove.
On the OEM-versus-aftermarket question: for hinges, drawer slides, and shelf clips, a good aftermarket equivalent from a known hardware maker performs the same or better than the original, and costs less. For finish-matched doors, panels, and decorative pieces, go OEM or go with a shop that can match the stain and sheen, because a mismatched door on a visible vanity is a permanent eyesore. We source through vetted suppliers, and we quote the part, the labor, and the warranty as separate line items so you can see exactly what you’re paying for.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Bathroom Remodeling Is Failing
- Doors that sag or rub the frame. A hinge that has lost tension or a screw that has stripped its hole in the cabinet face. The door is usually fine; the mounting point has failed.
- Drawers that won’t stay closed or feel gritty. Worn drawer slides, or slides that have collected hair and dust behind the vanity. Under-mount slides with soft-close mechanisms are the usual culprit.
- Swelling or softness at the base of the cabinet box. Moisture from a slow leak, a failed caulk line, or a mop bucket that sits against the toe kick. In a bathroom with no fan or a fan that vents into the attic, this happens faster than you’d expect.
- Peeling or bubbling finish on doors and drawer fronts. Wellborn’s finishes are durable, but constant steam without ventilation breaks down the seal at the edges first. Once water gets under the finish, the MDF core starts to move.
- A vanity that rocks or pulls away from the wall. Loose lag bolts or a wall anchor that was undersized for a solid-wood cabinet filled with towels. This one is a safety issue, not just cosmetic.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work actually costs in Garden Grove, quoted as installed prices, not parts-only estimates:
- Full bathroom remodel with Wellborn cabinetry: $9,000 – $28,000
- Small bathroom remodel: $5,000 – $12,000
- Bathroom vanity installation: $800 – $3,000
- Walk-in shower installation: $4,500 – $12,000
- Tub-to-shower conversion: $3,500 – $10,000
- Shower replacement: $3,000 – $8,500
What drives the range is the scope: whether we’re replacing hardware only, swapping a vanity, or rebuilding the wet area. A vanity installation covers removal of the old unit, setting and leveling the new cabinet, plumbing reconnection, and the caulk line. A full remodel adds tile, waterproofing membrane, fixtures, and permits. Every quote is a flat written price with a written scope before any work starts. If something changes mid-job, no work proceeds on that change until you’ve signed a change order. The workmanship carries our 365-Day Done Right Promise.
DIY or Call Us?
Some of this you can check yourself. Open every door and drawer and listen for grinding. Wipe a dry paper towel along the base of the cabinet box to check for moisture. Tighten a loose hinge screw with a wooden matchstick in the hole if it’s stripped, and see if the door sits right. Those steps cost nothing and tell you a lot.
Where DIY goes wrong is the plumbing and the wall anchoring. A vanity that pulls free from the wall can injure someone, and reconnecting a supply line wrong floods the cabinet within a day. If the cabinet box itself is soft or the vanity is separating from the wall, stop and call. We’ll give you a free estimate and a free second opinion on any written quote you already have. Call (888) 303-8980.
FAQs

Wellborn cabinet boxes routinely last 20 to 30 years when the bathroom is ventilated and the caulk line is maintained. Hinges and drawer slides are the short-lived parts, and most need replacing somewhere between 10 and 15 years of daily use. In Garden Grove’s coastal-influenced humidity, the finish edges and the caulk line are what fail first.
Often, yes. A stripped hinge screw can be filled and re-driven. A door can be rehung with a new hinge of the correct overlay. Repair makes sense when the cabinet box and finish are sound. It stops making sense once the core has swelled, because new hardware won’t hold in soft material. Call (888) 303-8980 and we’ll tell you which situation you’re in.
Hardware swaps and a single door replacement usually finish in a few hours. A full vanity installation is typically a one-day job, sometimes two if plumbing needs to be moved. A bathroom remodel with tile and a new shower runs one to three weeks depending on scope. We give you the timeline in writing with the estimate.
We identify your series from the cabinet label or from measurements of the overlay and hinge boring, then source through vetted suppliers, either OEM or a quality aftermarket equivalent depending on the part. We don’t claim to stock parts or carry them on a truck, but we can tell you what we’re ordering and what it will cost before you commit. We also service KraftMaid, Cambria, and Silestone if you’re matching or upgrading other pieces.
Written by the team at Rowan Construction Group Garden Grove, serving Garden Grove and nearby areas.












